Answer / Anshul Gupta

To connect a resistance decade box to a temperature transmitter, follow these steps: Connect one lead of the decade box to a temperature sensor (RTD or thermocouple) according to the manufacturer's instructions. Connect the other lead of the decade box to the input terminals on the temperature transmitter. Adjust the decade box settings to match the resistance value of the sensor.

NAME ANY TWO PHOTO CONDUTIVE MATERIALS?

1 Answers   DVC,

---

what deference between panel earth and systemearth

1 Answers   Tecnimont,

---

sir i m preparing for BARC but i am not getting any papers to prepare for this exam so please send me some sample papers to my i.d for the preparation of barc.

0 Answers  

---

Hi, am aniket, I got engineering degree in instrumentation and control, but as their were no job availabilities for engineer's post I started working as instrumentation technician I kuwait, so my question is is this technician's experience worth for getting the position of engineer?

1 Answers   Almeer Technical Services,

---

What is NAMUR standard and why its allways reletad with Sollenoid

2 Answers  

---

How do we MEASURE OR CALCULATE VELOCITY used to calculate REYNOLDS NUMBER??

3 Answers  

---

is any standard angle for thermowell mounting for horizontal and vertical pipe lines?

3 Answers  

---

What is the right procedure for adjusting the gap voltage of bently nevada vibration sensor?

3 Answers  

---

Where should we terminate the shield and why?

3 Answers   OPaL,

---

If we increase PI controller what will be action.

1 Answers   IMECO,

---

How to calibrate displacer type level transmitter (chemtrol make )for level measurement in hotwell , LP & HP heater ?

1 Answers   Matrix,

---

A DP Endress and Hauser flow transmitter is always tripping pump at low flow. set point is 74 cubic meter/hr. Thorough impulse line flushing and zero calibration has been done, yet problem persists. What do you think is the problem and how do you rectify this fault?

5 Answers  

---