Answer / santhosh b m

The following basic tests are conducted to check the quality and quantity of the diesel in the tanker:
1. Dip test - to check the quantity which is measured in each compartment.
2. Water test - to test the water content in the diesel which is conducted using a chemical paste
3. Density test - using hydrometer
4. Temperature - using thermometer
5. Viscosity test - using viscometer.

what happened when we supply a dc current in dc motor?? can it worked properly?

0 Answers  

---

what r substations?what r there work?why voltages r incresed and then reduced during distribution of power

0 Answers  

---

what should we do when the CT secodary gets open? how do we short circuit it? using tester or screw driver? not dangerous?

6 Answers  

---

Explain the following and how these are working with PLC Unit 1 I/O Module Card 2 Adaptor Card 3 Ribbon Adaptor 4 I/O bus 5 I/O Devices

0 Answers   Mayur,

---

How to conduct a Hipot test on a 11KV cable?

2 Answers  

---

i m electrical diploma holder i want to do plc $ Scada some body tell me which insitute is best for me near chandigarh

0 Answers  

---

how to calculate earth resistat in earthpit with earth testing kit?

2 Answers  

---

The undesirable property of an electrical insulating material is

3 Answers  

---

If a high resistance fault occurs,then what are the changes will happen in the system?

0 Answers  

---

HOW MANY EARTHINGS REQUIRED FOR GENERATER

10 Answers   Juniper Networks,

---

what is let through energy of mccb

2 Answers  

---

a)In a 3-phase 4-wire circuit, a circuit breaker is selected to protect the circuit whose highest fault level is 6.6 MVA. Determine the required minimum breaking capacity in kA. (Note: Covert 3-phase power in terms of kA to find answer.) b)Using the below, determine the required minimum making capacity in kA as a “peak value”. Rate breaking capacity (Icn) ka: Icn<= 1.5 Factor = 1.41 1.5

0 Answers  

---