What are all the points to be checked while decanting diesel
from tanker lorry to HSD YARD
Answer Posted / santhosh b m
The following basic tests are conducted to check the quality and quantity of the diesel in the tanker:
1. Dip test - to check the quantity which is measured in each compartment.
2. Water test - to test the water content in the diesel which is conducted using a chemical paste
3. Density test - using hydrometer
4. Temperature - using thermometer
5. Viscosity test - using viscometer.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What si the d/f b/w KVA & KWH, kvarh & kvar, kwh & kvar phase voltage & line voltage
What are the advantages of using distance protection schemes as opposed to normal overcurrent/ earth fault protection on high voltage feeders.
On what basis do you decide the ONAN (Oil Natural air natural) or Dry type transformer for a project?
What will happen if i replace a inductive proximity switch with photo sensor in a machine?
Grid fault level [KA]?
Is there any guideline say about display of earthing value near to earth pit
Circuit diagram of tube light without starter using electrical choke
how ct burden,magnetising current,ratio and knee point voltage are related & derived
What is meant by full pitched winding?
What is Fire Panel ? How it works ?
Is single load(eg: three phase motor) having all the components like positive,negative,zero sequence components during fault condition?
What is reverse power relay?
what is gas turbine intercooling ?
How earthing of switchgear system to be done.
HOW can i REuse the fused MLL LAMPS & GLS LAMPS at our factory