is power factor correction related with vector group of
transformer i.e:Dyn11?
Answer / sheikh
Vector group of transformer does not matter.
matter is kind of the load of your system.
Is This Answer Correct ? | 2 Yes | 1 No |
what is the most probable reason of failure of current transformer?
There is 15 KVA UPS using for single phase load.And 30 batteries of 12 V, 100 Ah are connected in series. Load is taking 15 A current.What will be the back up power for this UPS on same load?
1 Answers BS, Dynamic Software,
For Synchronisation of DG Sets Sometimes we people use NIC (Neutral Isolation Contactor) Instead of 4-pole ACB or any switchgerar..Please guide me why is it so????
4 Answers Piramal Glass Limited,
ELCP USE IN 3 PHASE SUBMERSIBLE PUMP? THEN USE 3 POLE 0R 4 POLE?
Why we call cable rating in SQ.mm.If it is 240 SQ.mm how much the diameter possible?is there any calculation ?
Why should The rating of 11 kV DO Fuse is in mulyiple of hundred(200 Amp. 40 Amp, etc) Ampere wheareses the its fuse elemnt has rating in just few Amp (< 12 Amp)? ( Is it jusy beacuse of factor of safty).
Explain the function and difference of Restricted earth fault, simple earth fault and sensitive earth fault with connection diagram.
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
what is difference between MCB & MCCB
how dia of wire and angles are calculated for overhead shielding wire to protect substation equipment from lightening strokes???
What are the differents between Breaker & Contactor?
Do anybody has a design software or tools for the selection and design of electromechanical components???