What is the cascade control system and where is use in
power plant give the detail with block diagram
Answer / ajjay
Basic of Cascade controller is that the output of a controller is input of anather controller.
Is This Answer Correct ? | 0 Yes | 1 No |
What is feed factor and its Importance in cement industry? How we can solve feed factor?.
What is an SCR?
how to calibrate a capillary type level transmitter for a closed tank in field? also what is the procedure for commissioning a capillary level transmitter for a closed tank?
there are two candidates p and q in an election.During the campaign,40% of the voters promised to vote for P ,and rest for Q.however, on the day of election 15% of the voter went back on their promise to vote for P and instead voted for Q. 25% of the voters went back on their promise to vote for Q and instead voted for P.suppose,P lost by two votes,then what was the total no. of voters.
i have one temperature TX in my loop check time once i was remove elament temp gose maximum then i am conect corectly but still now temp showing maximum what can i do this problem?
How we calculate orifice plat size???
What is Difference between Bench Set & Operating Range of Control Valve?
I have a MRE200 amplifier for controlling a mitsubishi servo motor, I would like to know how many pulses are required to rotate the servo motor by 1 degree and what must be the pulse width
WHAT IS INSTRUMENTATION?
generally transmitter power supply having some range(12v to 35v) but the out put(4-20 mA) must same for given input.If we vary the power supply voltage then output mA also to be change according to V=IR. Is there any voltage regulator in the transmitter ?
why generation of syncronized generator increases when frequency of grid is less then 50Hz & generation decreases when grid frequency goes up from 50 Hz, as comparision with set value entered in govering panel?
what is the advantage by using PID controller than P& PID?