Answer / tushar sangeet senapaty

Automation is a method to do all the machinery job in such a
way that all are welly executed in a simple prosses i,e the
control of the total industrial function in
SCADA(Supervisory control and data acquisition system ) or
in a logically manner i,e PLC(Program logic control).
SCADA-It's a computerized control programme in which all
machinery work done are showed in graphics page as well as
controlled by this system.
PLC-It is a logical programme in which some method are used
that are ladder diagram,FBD & STL to solve the industrial
control situation by single handily with this logics.

Answer / shawon

Automation is a system concept utilizes instrumentation system to perform certain task or sequence of operation in an automatic manner or without human intervention.

Answer / mhax

Automation is fully automated process.It means that theres
no human intervention

Is there devices to convert mechanical energy/rotational energy into electrical energy.......? PLease suggest me....

6 Answers  

---

Somebody can explain me about >Critical Loops, calibrations, ESD critical Loop checks, Logic Diagram / Cause & Effect checks for ESD loops,

0 Answers  

---

IS THEIR ANY AGEING EFFECT ON FLOW NOZZLE, ORIFICE, MANIFOLD, OR TRANSMITTER ?

1 Answers  

---

How to calibrate level transmitter with use of HART?

0 Answers   Samsung,

---

Profibus DP is a multi-master system. Would it work on RS-485 4W or not, and justify your answer

1 Answers   EIT,

---

IS there any effect of vortex in low pressure side of the transmiter after the orific in feed water line? if yes then what is the calculation?

0 Answers  

---

what is loop?

4 Answers  

---

How to work DCS? how to get the signal from Field Instruemtns to PIB to Console?

2 Answers   Alstom, Invensys,

---

how to set calibration range in a DP transmitter to measure level for a closed tank and for an open tank,and also please explain me how to set calibration range for a DP flow transmitter in a line ?

1 Answers   CCL Products, IOCL,

---

how do i tune dearator pr control valve using PID. we set the set point is 0.6kg/cm2 now i want 0.5 to 0.7kg/cm2 limits so what should i give p,i,d values. then pls explain how do set pid values for control valve tuning?

0 Answers   SEWA, Sharjah Electricity and Water Authority SEWA,

---

what happen if i increase height of displacer type LT.accuracy or sensitivity are affected.why?

0 Answers   Essar,

---

what is mass flow meter, working principle of mass flow meter and its installation.

2 Answers  

---