What is the purpose of reactor.why we used in over head line?
Answers were Sorted based on User's Feedback
Answer / shanthipriya.r(design engg)
reduce hormonics and improve efficiency, so only we used
reactor in over head line.
Is This Answer Correct ? | 4 Yes | 0 No |
to compensate capacitive coupling between line to ground
Is This Answer Correct ? | 0 Yes | 0 No |
In a power conditoining unit (inverter) of a solar plant when we measure the d.c. current fed by different strings of solar plates to inverter, the current in the negative wire is less almost by 1 ampere to the current in its positive wire say current in positive wire 5 A , then current in negative wire of the same string is 4 A. Since the current entering should be equal to current leaving then why the current is noticably less in negative wire.
in power generator normaly voltagr betwween esth to neutral is 0 but my work place generator show the volatge is 60v any body know why? thanks
what is the main purpose of line PT and bus PT?
1.how to calculate energy units in our home at singe phase, 2.415V,63A wiring what will use thickness of wire
why fault current time duration is calculated for 1 minutes?
1 Answers Rockfort Engineering,
How to calculate % Impedence?
Why only plate(copper) Earth pit given for neutral earthing? why not pipe(G.I) Earth pit?
If short circuit ratio is high is it bad or good for a machine then tell the reason...
In neutral the current will flow or not?
Why we use Fuse in transformer in secondary side.Why we dont use fuse in primary side?
calotropis is an example of the following phyllotaxy
why the emf of a cell more than the terminal voltage when the cell is delivering current?