Answer / m. saqib ali nafees

Thanks for answer, please tell me its formula

Answer / thirus

600 meters

We do have a problem in the company that is one PT connected to PlC which is mean 1 out of 1 in PLC system we do have the PAHH is 55 mbar and PALL 8 mbar with a timer of 15 sec for the PAHH the problem started when PAHH goes more than the set point which is 55 it reached up to 71 but due to timer doesn't trip . We force it and we checked everything nothing there . We replaced the transmitter problem still there the reading goes more than the 55 bar the range for transmitte is 0- 60 mbar . So we did loop check , aculaizing valve , wiring all are okay . What the possible causes for this ???

2 Answers   National Petrochemical Company,

---

What is the advantage of using locally fabricated hook ups over Pre fabricated hook ups in process instrumentation?

0 Answers   Engineers India Limited,

---

how to turbine speed measurement?

0 Answers   Jindal Steel and Power,

---

Dear Friends, we are planning to design Power distribution and Fiber optic in the same cabinet.Like Front side Fiber optic and Rear side Power distribution.Is it any possibility of problem occurs like interference etc? Your answer is highly appreciate.

0 Answers  

---

What safety precautions you will adopt to work on Steam service control valve?

1 Answers   QAFCO,

---

what is stability

2 Answers   IOCL,

---

what is the difference between two wire transmitter and 4- wire transmitter

3 Answers  

---

what is use single seated and double seated valve?

2 Answers   Doha Petroleum Construction DOPET,

---

why we use 3 wire rtd direct wiring for temperature measurement instead of temperature transmitter like bearing temperature

0 Answers   ABG Energy,

---

why 4 to 20 ma used at 0 set

2 Answers   Borouge, Yokogawa,

---

IF TX SHOWS SLOW RESPONSE, WHILE A CLOSE LOOP AND WHEN WE PUT THE CONTROLLER ON MANUAL THE PROBLEM RECTIFIED, SO WE CAN SAY THE PROBLEM IS IN

1 Answers   IFFCO,

---

why the steam drum and deaerator level transmitter range is in negative MMWC to zero

3 Answers   Emerson, Jindal, JKPM,

---