What is main cause of cable's terminal point burned in Lug
on high temperature although lug and cable selection is ok
as per stantard and also tightness is ok as per situation.
so please take in deep and tell correct answer thanku.
Answer / k.prakashchandra
Bad crimping and insufficient contact area or lower 'lug
current rating'.
Is This Answer Correct ? | 7 Yes | 0 No |
What is cross over distortion? How it can be eliminated?
11 kV line deraction check by an Engineer.
Why a tesa lamp is glow between two phase?
why all transformer colour is same?
Why are use 22 kv 3ph supply ?
how to design step down 12 V, 1mA small transformer from 220 V AC? Because according to VI relation and power transfer it results bulky...
Why the motor take high starting current for long time(10- 15 sec) which is connected to Blower as compaire with a motor which is connected with pump with same rating?
Sir Power transformer :- (in generating station) Alternator terminals side - Delta HT transmission line side - Star Why?
How to calculate the cable size in sq. mm. when the load is given in KW?
what is the full form of KVAR
How to increase solar cell efficiency ?
What is super thermal power plant? and how it will differ from normal thermal power plant