What is the difference between UPS and SMPS?
Answers were Sorted based on User's Feedback
Answer / pandey brijesh
The Main Difference Between UPS and SMPS is that SMPS uses high frequency transformers while UPS uses low frequency transformers.
|Is This Answer Correct ?||54 Yes||8 No|
Answer / d.ramesh classes
ups- uninterrupted power supply for ac load
smps - switch mode power supply for dc load
by D.RAMESH CLASSES
|Is This Answer Correct ?||38 Yes||7 No|
Answer / yury
UPS gives power supply to AC load when supply is interrupted
SMPS give pure DC supply at different voltage with almost zero
|Is This Answer Correct ?||18 Yes||9 No|
Answer / rajeswari
UPS mean power supply to AC loads by storing DC where are SMPS means without storing DC directly it converts AC to DC just by switching the AC supply that's why it is called switching mode power supply
|Is This Answer Correct ?||8 Yes||0 No|
Answer / krishna
SMPS are like a conditioner of electricity supply for a building, house, etc.
UPS are the emergency backup power supply for vital computer based systems
|Is This Answer Correct ?||2 Yes||0 No|
Answer / fakir
Life ma first time searc karu ema pan uluu banavo cho.
Aa Badha dhandha band kari bhik mago
|Is This Answer Correct ?||24 Yes||31 No|
Why two nos. un-tensioned wires are placed inside the PSC poles used by powergrid in RGGVY works.
How to do stting of vl250 siemens MCCB
why we use 50 hz frequency in india .. why not 60 hz
why are transformer rating in MVA
what is the effect of PF on alternator sizing?
how can i get the entrance exam papers
What are the specifications for conducting earth leakage test as per IEC standard?
if we have a industrial load of 400 kilowatts with 415 volt AC then how much total harmonic distortion (thd%) should be acceptable for steady power system.
3 shows a 415 V, 3-phase generator supplying a 3-phase 415/110 V transformer. Draw the individual and combined impedance diagrams to a base of 10 kVA. Determine the system fault kVA and the fault currents at the 415 V and 110 V busbars for short circuit faults on the transformer input or output terminals. Work in p.u. values of impedances.
in catridge heeter watts =110, 260 v , i checked in multimeeter meeter shows 50 ohms but oms law r=v square /w 260*260=67600, and 67600/110=614.5 ohms how to caluclate exact ohms in heetre s
Hi friends. is it possible that SCADA System through RTUs can connect Via PLCC Communication carriers ? thanks
10. THE MOST COMMON TYPE OF THREE PHASE IN UNSYMMETRICAL FAULTS IS ........