Answer / k.prakashchandra

-24 V dc means potential difference from + terminal or O
potential.If we earth the midpoint 0f 48V DC source ,then
one terminal is +24V and the other -24V with reference to 0
potential ground which gets connected to all metal bodies

Q. calculate the value of the resistor to be connected in series with a 100W; 230V lamp so that the wattage of the lamp is reduced to 35W

8 Answers  

---

two phases with neutral supply can be taken in 3C X 10 sq.mm cable .

0 Answers   SPCL,

---

What are test values for an 63 KVA and 100 Kva Distribution Transformers for the following typical tests 1)Magnetic balance 2)Short circuit test 3)Open Circuit test 4)Vector group confirmation test .please give me the standard values for all the above tests.

0 Answers  

---

what type of protection and safety req. in the 220kv substaion and area around the substation

2 Answers  

---

what size of copper busbar use for 11kv 630A

3 Answers   ABB,

---

why we use perllel conection system in the wiring?

4 Answers   Airtel,

---

Why different Pressure switch used in marine boiler water circulation system

0 Answers   MMD,

---

How can we Run three phase motor when only single or two phase supply is available ??

3 Answers  

---

why use generator Earthing/Graunding.

4 Answers  

---

why 3 phase motors are preferable over single phase motors ?

4 Answers  

---

USE OF 8 WAY PAN ASSEMBLY

0 Answers   TCS,

---

how can i find ct ratio of meter by seeing name plate of meter and how it should be used in MF calculation if it shows only-/1???

0 Answers   Harshal Electrical,

---