Answer / k.prakashchandra

You can not use metering ct as the it does not measure
current beyond 150% 0f rated.You can connect terminals of
diff relay in series with back-up relay.

how to calculate the multiplying factor for energy meter with CT ratio given

23 Answers   Bhel, Dalmia Group, DIFC, Fedco, Hindustan Unilever Limited, Lupin, MahaDiscom, MAL Pakistan, Myunghwa Automotive, Panchshil Infrastructure, Regala, RVPN, VIPL,

---

during parallel operation of two ac generator which condition must match before taking both parallel i.e speed /voltage rating /kva/exciation

2 Answers  

---

could an induction motor be used for regenerative braking in electric-train control? in this type of application would some scheme have to be devised to obtain low synchronous speeds while braking? would induction-motor drive, therefore, be suitable for passenger service?

0 Answers  

---

We have one 500KVA transformer. We have tested REF relay and commissioned. After one and half year, due to some ground fault in one of the DB circuit Transformer tripped by REF relay. What will be cause and remedy. Please advise?

1 Answers  

---

In motors how many types of cooling systems were used?

0 Answers   NTPC,

---

why autotransformers are not safe for supplying low voltage from a high voltage source?

5 Answers  

---

can we transmit power with out cable if it is possible how it is possible.

2 Answers  

---

how to calculate the capacitor to maintain power factor?

0 Answers   Bosch,

---

What is the comparison of PILC and XLPE cable

0 Answers  

---

how can we calculate air compressure capacity

1 Answers  

---

Hi How can you start-up the 40w tube lite with 230v AC/DC without using any choke/Coil.

5 Answers  

---

Sir, how to calculate the voltage drop and short circuit current of cable. please give me example and formulas.

1 Answers  

---