how to convert single phase supply to 3 phase or 3 phase to
single..?
Answers were Sorted based on User's Feedback
Answer / aruna.pyla
1ph to 3ph:scott connection
3ph to 1ph:cyclo converters
Is This Answer Correct ? | 6 Yes | 1 No |
Answer / gopi
from rotory converters we can obtain the three phase supply .
Is This Answer Correct ? | 4 Yes | 0 No |
Answer / gopal manda
it can be possible by scott connection of two single phase
transformer.convert single phase AC to 3-phase AC supply
Is This Answer Correct ? | 3 Yes | 0 No |
Answer / basavaraj v madiggond
You may convert 3 phase supply to equivalant DC voltage and
then again convert it to 1 phase AC voltage. The same way,
convert 1 phase voltage to DC and invert it to three phase
voltage
Is This Answer Correct ? | 2 Yes | 2 No |
Answer / sachin thakare
using scott transformer one is main transformer other transformer in this connection using two phase and take voltage 1 phase
Is This Answer Correct ? | 0 Yes | 0 No |
Answer / shariff
It can be possible to convert the 1Phase to 3 phase by
using the capacitors..in the same phase to advance a angle
120 degrees.. And # phase to 1 Phase by using the SCOTT Trf
connection.
Is This Answer Correct ? | 0 Yes | 1 No |
Answer / ramsiddarth
rotory phase convertor is used to convert single phase to three phase
Is This Answer Correct ? | 0 Yes | 1 No |
what is the operation of UPS ? can any one answer me?
During the troubleshooting of an inoperative shunt generator, you found the voltage to be 2+ volts; what is known from this. Is it (1). odds are the armature is good (2). odds are there is no field current flowing in field windings (3). odds are the armature is bad (4). both 1 & 2 are correct (5). both 2 & 3 are correct
is this the formula of building wiring to get the main breaker.Watts/volts*.8%+higher motor*(25%)=ampere. yes or no or send the correct formula for building wiring.
IF alternator SCR value will be high means what happen in alternator efficency at operating power factor of 0.8
Dear Brother can u tell the proper size selection of cable & the fault level calculation of braker, busbar etc. pls mail me at azeemk30@gmail.com
why odd hormonics only will effect the power system.why not even hormonics
What is diversity factor and how to calculate it
2 Answers Al Faraa, Amul, Pentagon, Sobha Developers,
What is the purpose of REACTOR in GIS substation?
How much is the starting current for HPMV lamps. How many lamps can u wire in a circuit
insulators advantage in transformer yard?
what is the safety points of vaccum circuit breaker.
what is the difference between ELCB and RCCB