Answer / k.prakashchandra

If this condition is on no-load, replace tr

Answer / kj

First check the 11kv is correct. If the 11kv is different
on each phase the LT side will also be different.
If 11 kv is OK and the voltage is different on no load the
fault is in transformer as answer above.

What are the temperature elements?

0 Answers  

---

A 50Hz,4-pole,3-phase,star-connected synchronous motor has a synchronous reactance of 12ohmsper phase and negligible armature resistances.the excitation is such as to give an open-circuit voltage of 13.2kilovolt.the motor is connected to 115kilovolt, 50hertz supplying. what maximum load can be the motor torque,line current and power factor?

0 Answers  

---

Why a Transformer Noise during its running condition ??

11 Answers   NTPC, UPPCL,

---

for high freq ac,why we first convert AC to DC and then DC to high freq.AC

0 Answers  

---

Why current transformer is earthed??

2 Answers  

---

The 3 phase 400 hp 440 volt slip ring induction motor do not take one phase amps why ? The motor is running good condition

0 Answers  

---

if i conncet ct with ct ratio of 600/5 to an energy meter having ct ratio of 100/5, the reading show by the meter will correct, if wrong is there any method to calculate correct value with shown value, if yes please state it.....

2 Answers  

---

Car battery + terminal allways biger than - terminal! Why?

2 Answers  

---

Difference between earthing & grounding.?

0 Answers   Nitco,

---

What happens with squirrel induction machines if the ends of rotor conductors are kept open? Explain

3 Answers  

---

I am having a DG set.The 415 V from Generator is step up to 460 v and then the same is used for Induction furnace. before Step up, I am connecting LT load to my factory use. When Induction furnace is in service from DG, when i try to start a motor, the generator is tripped.Please tell me the reason.

3 Answers  

---

How does solar power system work?

1 Answers  

---