what ll happen to current if two phases get short circuited
Answers were Sorted based on User's Feedback
If current in two phase get short circuited then a large
amount of fault current will fow through the two phase and
the shorit circuiting medium.but current in the 3rd phase
wil be zero.this will create an unbalance situation and the
consumers equipments will be affected if proper protection
systems are not provided.
| Is This Answer Correct ? | 26 Yes | 3 No |
Answer / saifur rahman
Two phase are short current will be infinite
I=V/R when short circuit R will be zero thats means I will be infinite
| Is This Answer Correct ? | 0 Yes | 2 No |
On load tap changer (OLTC) explode? Transformer Vector group: Ynd11 Rated Power: 353MVA Rated Current: 693A Voltage:294/20KV OLTC Type: T III Y1000 110/c 12193w Max Operation Current: 295A Step Voltage: 550V Arrangement in Tx windings: Y Connection Problem: Damage of Unit 1 Generator Transformer On Load Tap Changer (OLTC) Description of Incident: 9.00 a.m. :- Generator No Load test on excitation system started 10.30 a.m :- Carried out AVR change over test 11.30 a.m :- Preparation for Generator Manual Synchronizing test 12.00 a.m :- Manual Synshronizing test started. Observed incoming generator voltage higher than running voltage. CECR operator operated Generator Transformer OLTC to bring down the incoming generator voltage 12.03 a.m :-Generator Transformer abnormal alarm operated at Gen.Control Desk (CECR) CECR operater at Generator transformer bay informed that the transformer oil splashed out from OLTC. CECR operater informed that he heard explosion inside OLTC. Observed Oil level & Oil Flow alaram operated at Tranformer local annunciator. 12.05 am :- CECR operator 'Open Gen Field Breaker” 12.10 a.m. :- Elec1 team inspected the OLTC and found the OLTC rupture disk was broken and oil spilled at OLTC area. - Elec1 found the OLTC top cover bulging. Do anyone know why and possibility cause happen in this OLTC.
What tests should i carry over on a newly rewinded DC Generator with voltage rating of 38 volts and current rating of 350 amps, to certify that the machine is OK?
can i able to get bhel previous exam question paper?
Frequency of rotor emf in induction motor is around A same as stator frequency B 50% C 5 % or below D 30%
how much flux density of CRNO core
Which device is used for the source of emission of electrons in a crt?
i have a wire.and the current flowing in that.when we cut the wire then why dont we seen the elactrons....
Whats changes in Transformer Oil BDV in changes in temp or Climate?
what is excitor response of an excitor?
Can we use same copper cable for both AC & DC power.
What is an ac motor?
area control error
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)