Interested to Buy Any Domain ? << Click Here >> for more details...
What is the reason of using bus-bars on the secondary on the
LT transformers?
- 2 Answers
- 4539 Views
- I also Faced
- E-Mail Answers
Answer Posted / venkatraman.s
hi friends, this question is most important one for all interview. ans is HT side voltage is high so current is low but LT transformer secondary voltage is low current is high,so we are not connected more cables in TB side so we are using bus bar. its formula is KVA/1.732* volage(HT OR LT)
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
Why current shoots up in the secondary on the knee point voltage during saturation test of CT? How core saturation effects the secondary current (while the primary side is open)? What the logic behind this?
why normally Generator rating are between 11Kv to 22Kv?
Dear sir, iam completed iti ncvt electrician 2000-2002 & diploma electrical eng completed 2008-2010 distance education in rvd university, still i got B licences only but my working company want C licences, how to i get c licencese pls reply me iam in critical situation thank you karthick 9841637803
PAC and simple Ac different
Draw a 230kv two-bus bar system showing the following. 1.Two generators (150MW) each connected through one 15.75/230KV transformers 2. 1 outgoing lines 3. Two 230/130 KV transformers 4. BUS PT's 5. CT
In convertor can we use rectifier thyristor in place of invertor thyristor with explain.
in Telecom DC system-why positive +ve is made earthed.and - ve is fed to load.
how much cable size required for 70 kilowatt load.
What is the effect of pi controller on the system performance?
what are factors to be consider in electrical installation like load factor,diversity factor .....
66kv under ground cable how to layaing in ground any special case two ckt r runing
What kinds of decision are made about CT from it's Knee point(voltage & current)?
difference between semiconductor & conductor & insulator?
What are the major reasons for balancing hydro-thermal mix?
What is the reason of polyphase induction motor tripping suddenly on high current during running at 70% laod? Motor IR , winding resistance & inductance balance. Motor no load current is balance and ok as per mgfr. data.
