Answer / k.prakashchandra

I think tachometer is a generator with voltmeter calibrated
to read rpm .For flywheel you can use a pulley .

What is rms value wher it is used??????????

1 Answers  

---

if there is nutral in phase why we use earthing wire and grounding? even at fault condition the fault current flows to neutral (it is a lower path)

0 Answers  

---

What is third harmonic?what is the effect of it?

0 Answers   GMR,

---

what does happen if generator frequency fall in running condition & what should require immediately

4 Answers  

---

What is the working principle of servo motor? And explain it.

0 Answers  

---

50 electric bulbs are connected across supply of 220 volts. After one bulb is fused remaining 49 bulbs are again connected to same supply. which case will have more illumination & WHY????????

5 Answers   KJ,

---

what are the steps involved in generator load test?

0 Answers  

---

why overcurrent fault occurs in power system.

1 Answers  

---

State the methods of improving power factor?

0 Answers  

---

when the supply of MSEB is cut off & all the load of the industry is driven on generator at that time the capacitor which is connected in industry for power factor control is switched off why?

1 Answers  

---

I have been short listed for sydicate clerkcal post .i have interview on 15th sept..i want to ask if i don't know kannada to read and write they won't allow me to attend the interview?Do send u r reply.......

1 Answers   Syndicate Bank,

---

Why do you get a typical sound when the transformer is put into operation?

4 Answers   IIT,

---