Answer / raju

nothing

this taken some constant

take the form factor 1.1

11 kv
33kv
132kv

Answer / ubaekwena humphrey

to maintain a uniform factor

Answer / manish sharma

In the case of a sinusoidal wave ie., an analogue wave, the
form factor is approximately 1.11.

Form factor of an alternating current waveform (signal) is
the ratio of the RMS (Root Mean Square) value to the
Absolute Average Value (also referred to as the Practical
Average Value) of the waveform.

Therefore due to form factor our volatges are 11KV, 33KV,
66KV ...

How can we design a HVAC Plant room which includes AHU,FCU,Chillers,Cooling towers, Pumps etc & how will they work? any Drawing if possible?

1 Answers   TCS,

---

I have made a 3 phase thyristor full bridge rectifier. But at the moment it is working only for the half bridge operation. Both the half bridges are on operation separately but when i put it into full bridge operation the oscilloscope output is zero. I rechecked that the pulses are correct for each thyristor. what could be the possible reason for this?

1 Answers  

---

Why we are use dol starter up to 10 hp

1 Answers  

---

why an ideal voltage source has low internal resistance????

1 Answers  

---

What does bode plots shows?

1 Answers  

---

how we can calculate chiller required ampear?

1 Answers  

---

What happened if C.T mount at any cable or Bus bar in wrong direction . C.T going on proper work or not . C,T direction is essential thing to properly work.

1 Answers  

---

How to select HT/MV cable size ?

1 Answers  

---

i want to know about torque of slip ring induction motor

1 Answers   Ambuja,

---

what is pressure relief valve?where it is used????

4 Answers   Mecon,

---

how to calculate the settings for shaft ct protn in hydro generators

1 Answers  

---

Transformer rating=> 15/20 MVA.Why there are two raings? What should be the rating of the fuse at the secondary if the voltage level is 13.8KV/4.16KV?

1 Answers   Bhel,

---