Answer / k.prakashchandra

As the voltage is high ,the current is less.So ,instead of
having 3 windings of line voltage ,you can have 3 windings
of phase voltage to save on insulation and others.Iron
losses are also reduced.

why not starting switch first connect in direct on line starter?????

0 Answers  

---

How DC earth leakage currents can be reduced ?

0 Answers  

---

Why we use CT on differant phases of 2ph.PT detection for brush-less static excitation of 3ph.,400v Synchronous Generator? What happen if use CT on same one of VT phase?

2 Answers   Hydropower,

---

how can we detect that which is receiving side and which is sendind end of a trnasmmison line by just seiing it?i.e its which end is coming from genertaing and distribution side?

5 Answers  

---

What's the difference between non break power supply and non break non short break power supply

0 Answers  

---

why do we need to use 3c+3e cable, normally i select only 3c+e cable and i think it is enough. pls explain the usefull of 3e cable ( in this project the earthing system is well done)

0 Answers  

---

Why the output of OP-AMP is always less than Vcc?

0 Answers  

---

a governer in an Ic engine controls the

0 Answers   Caterpillar,

---

why field winding is placed on rotor winding not on stator winding in case of synchronous machine?

13 Answers   HAL, TATA,

---

is it possible to flow currnet between earth and nutral wire in a circuit???

2 Answers  

---

In a Impedance Based Distance Relay (Quad Characteristics) - Could there be two different Line Angle(RCA) for Ph-Ph & Ph-Gnd? If So Kindly Let me Know.. Where, What are the advantages of the same?

0 Answers  

---

what effect on electrical equipment if PF is gone over 0.996 in leading when provider say that its keep in minimum 0.996lagging

3 Answers   ABB,

---