What are the factors considered for the selection of cable?
Answers were Sorted based on User's Feedback
Answer / shaheer ap
1. Nature of meterial
2. Voltage level
3. Current carrying capacity
4. Voltage drop
5. Over load capacity
Is This Answer Correct ? | 64 Yes | 7 No |
Answer / nvyibrahim
1.Type of cable Instalation
2.Type of cable based on site requirments and techno-economy
3.Main operating ratings
4.Core arrangments cable size,Termination space available
5.shielding requirments
Is This Answer Correct ? | 19 Yes | 3 No |
Answer / thanu
Nature of meter, Voltage level
Current carrying capacity
Voltage drop
Over load capacity
Is This Answer Correct ? | 10 Yes | 2 No |
Answer / sayan banerjee
1. current carring capacity based on its cross section.
2. insulation types(pvc,xlpe,trs)
3. no of cores
4. voltage level(HT / LT)
Is This Answer Correct ? | 8 Yes | 2 No |
Answer / bello ibrahim
1. amperes required
2. ambient temperature
3. voltage drop
4. conductor material
5.conductor insulation type
6.cable distance
7.device characteristics
8. installation method
Is This Answer Correct ? | 8 Yes | 4 No |
Answer / mogiti
1 Full load current
2 Atmosphere
3 maximum voltage
Is This Answer Correct ? | 2 Yes | 3 No |
what is submersible pump?what is different between motor and sub motor?
How can we calculate the power factor of an electrical appliance ? Is there any formula ? Is there any meter around to calculate it ? And how to use that meter ? thanks
One VFD is possible to connect two motors at the same time?
What is short circuit analysis of electrical networks?What are the procedures to be followed for its calculation?
WHAT WILL HAPPEN IF INPUT SUPPLY OF RCBO IS CONNECTED TO OUTPUT SIDE
What is application of MCB & How it works
why voltage swells and dips???
Why Drives are used to run AC motors?
What is the difference between Static and servo controlled voltage stablizer?
What is size 00, 01, 1 etc., in HRC fuse types?
What are IP protections used for electrical panels, JB, equipments installed in explosive zones like Petrochemicals, Oil & gas
how can i increase the excitation on full load running engine??