Interested to Buy Any Domain ? << Click Here >> for more details...
when an eddy current probe is installed inside of a turbine
or compressor in case of probe problem same as:crash of head
of probe,changing the scale factor because of low measuring
gap(physical gap is ok(example=1.14mm)but voltage is
reduced(example=-6 volts),is any way to check the probe,when
the ohm of probe is ok.thank you,(Karim Tavakoli)
- 1 Answers
- 2738 Views
- I also Faced
- E-Mail Answers
Answer Posted / kumar
proximity probe tip is wound on coil if any damage in tip won't get reading. proximity probe installed in -6v gap voltage didn't get proper microns because that time magnetic flux line is not created fully so we installed probe in -10v this time probe 200 microns/mills or 100 microns/mills we get exact variation in probe
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
how to calibrate electro pneumatic positioner 8013 mil controls ltd ?gsr
In most instances, Inertia processes are quite uncommon. Give an example of a combined Resistance and Capacitance situation.Describe an application, which according to your understanding of the subject matter, comprises of both Resistance and Capacitance effects.
our kks tagging is crossing more than 12 character please suggest how to take tags in the DCS
What are the interlocks we have to check during the start up of LP/HP compressor?
How d.p. Transmitter can be applied to open tank?
Explain about safety integrated level protection? . How it was differ from other protections ?
why we r opening HOT BYPASS valve during startup of a compressor?
What do you know about gail?
How to Calibrate Level Switch in field
A valve in series with an orifice plate (DP transmitter), is aligned for constant pressure in the pipeline, if there is an error dx, How to align it in process.
Full form of KKS when use DCS.
-/5A. What is the meaning and limitations of this in energy meter constant. It is a 3 phase LT Energy Meter. If this Energy Meter is connected through a CT of ratio 200/5 Amps, then what is the multiplying constant and how its will be calculated.
how to check earthing,what is minum ohms for proper earthing
what is diffrance between FF & SMART, explain with difination
why we are using digital signals for I/O & how to measure this signals is getting or not ?
