Answer / k.prakashchandra

Generally , P means potential ,M - Mains (incomer) L -load (
line).Po- Neutral.M and L are for CT terminals incoming and
outgoing respectively, when CTs are used

Answer / k.prakashchandra

In other words P1-P0,P2-P0 and P3-P0 are for potential
coils.M1-L1,M2-L2 and M3-L3 are for current coils.

In star delta Schematic can we connect OLR in delta circuit

2 Answers   ABB, Lanco,

---

I AM FROM ELECTRICAL ENGINEERING ? I AM ASPIRING FOR "BHEL".HOW I HAVE TO PREPARE .ON WHICH TOPICS TO BE CONCENTRATE MORE.PLEASE GIVE FULL DETAILS OF WRITTEN EXAM.

0 Answers   Bhel,

---

How to calculate the 2500 Kva Transformer losses Primary 11KV Secondary 415volts

1 Answers   Laurus,

---

Why we find the sensitivity for the CT's to check?

0 Answers  

---

WHAT IS DIFFERENCE BETWEEN POTENTIAL DIFFERENCE AND E.M.F?

2 Answers  

---

How to check the thermocouple is correctly connected to cable for K type? (i,e positive pole is connected to non magnetic conductor and negative pole is connected to magnetic conductor)

0 Answers  

---

what is high tension ? specify the range?

3 Answers  

---

The screw thread commonly used for transmission of motion is one of the following types of threads

0 Answers   Caterpillar,

---

what happen if generator of micro hydro running at only a small percentage of its capacity, as a comparison, if the diesel generator that runs on only a fraction of its capacity there will be a wet stacking

0 Answers  

---

discuss thyrister convertor type of AVR.

1 Answers  

---

current transformer balance the power level on both sides. e.g in case of step up, at secondary side voltage rise but current decrease and vice versa in case of step down transformer. but how this power level remains same in case of current transformer and voltage transformer

0 Answers  

---

If two Transformers are connected in parallel having impedance of 50KA in both transformers will the impedance increase or decrease after connecting transformers in parallel?

0 Answers   Posco,

---