(1)WHAT HAPPENS WHEN SUDDENLY LOAD GIVEN TO THE INDUCTION MOTOR ? (2)CAN WE MAKE WOOD AS MAGNET ? (3)WHAT IS THE VALUE OF MAGNETIC FLUX DENSITY IN TRANSFORMER ? (4)WHY WE ARE USING ELECTROMAGNETI NOT ELECTROSTATIC IN MACHINE ?

0 Answers   Cognizant,

---

What is the Different between CT Class-0.2 & Class-0.2s ?

3 Answers  

---

what is the meaning and difference between ELECTRICAL DRAWOUT and MANUAL DRAWOUT?

3 Answers  

---

why there is a 2 slits in three pin's earthing pin?

1 Answers  

---

in 132 kv transformer , in which range of transformer oil bdv required ? if it has around 50-55 , then how it was insulated the winding ?

3 Answers   Voltamp,

---

how to test YNyn0 vector group in transformer?

0 Answers  

---

in thermal power plant the steam produced is made to cool after falling on the turbine blades. my question is why this is done while the same is needed to heat up again. "jab pani ko wapis garam hi karna hai to thanda kyu karte hai"

11 Answers   Bhel,

---

what happen if we give square wave instead of sine wave to the transformer

8 Answers  

---

when the rheostat kept in minimum to maximum position in motors what will happen?

7 Answers  

---

According to ohms law voltage proportional to current, then why should current rating is low with high voltage rating in transformer?

5 Answers   KEC,

---

How is the gain affected by the introduction of feedback in a control system.

0 Answers   GE,

---

How to Calculate Current Rating of SDFU (Switch Disconnector Fuse unit) for Protectionof Capacitor Bank connected to Busbar of 800Amp,in LV side of 11/0.433KV, 250KVA Transformer?

0 Answers  

---