Answer / murafiq

NGR used for limiting the ground fault cuurent that is
installed in between generator neutral point and earth in
case of fault that limit the fault current that is of
diffrent type resiatance type, reactance ,petrson coil
earthing. In case of one phase fault that NGR limit the
current and relays detect that and trips the generator.

Answer / sivashanmugam

neutral grounding resistor as like that of an earth ... in
generating station most probably transformer is an star to
delta connection generator side delta to star connection i
the transformer side grounding is not possible in case of
that ... one earthing transformer will be palced its an
zigzag winding for grounding the transformer side earth
bcos its an delta conn ... for neutral grounding resistor
ter will be an ngr panel in generator side unequal of
currents in phases grounded in ngr .... am not sure in this
answer if u peoples refer further mail me thank you.....

What are protections for dty type transformers

0 Answers  

---

sometimes, eventhough the HV side of the transformer is opened there is a voltage in LV side .How is it possible?

4 Answers  

---

If load current is 70amps or 50amps what range of CT to install for ampere metering

3 Answers  

---

Why a transformer is known as a static device?

7 Answers  

---

In CDG type IDMTL realy O/L , E/F, O/C which are used for out going feedrs,on R-phase o/c element, Y-phase , e/f elecment and on b -phase o/c element will be connected . Why the earth fault on center phase only, why not on other two phases?

2 Answers  

---

Hello, I am just preparing my self for a university interview and struck on the 11kv ring main unit system network. I just know that ring main unit has total three breakers, fuses and use to supply a power to any load/ building without any interrupt. But i am not be able to visualize the connections, either Ring main unit getting power from two different power sources? or there is always one feeder in complete ring circuit??? I would be highly thanks full of you help me.

1 Answers  

---

one cable insulation resistance 200 mega ohm. how find 250 meter cable resistance.

2 Answers   NTPC,

---

Can we use a window type neutral CT instead of a bar type neutral CT. We have an issue with a neutral bar type CT of 800/1 ratio with a Circuit breaker NS800L shneider type, and we want to change it with a window type. Pls advise. Thanks

1 Answers  

---

What are the types of the glands and difference between single and double compression type of cable Glands.

0 Answers   ABC, All Trades Electrical,

---

what is a,b,c,d checks diesel generator?

1 Answers   AFMC,

---

Dear Sir / Madam, Actually we requied 64 A MCB, But i have 32 A MCB = 2 No's this two i have to make series connection and we usw any place? isit possible or not......

4 Answers   Hindustan Unilever Limited,

---

what is the difference b/w single and three phase circuits?

1 Answers  

---