Answer / sahil

Knuckle joint is used to connect two rods whose axes either coincide or intersect and lie in one plane, which are subjected to transmit axial TENSILE force on other hand cotter joint is used to connect two co-axial rods, which are subjected to either axial force or axial compressive force.

Answer / kgm

motion ccan transferred in all degrees is called knuckle
joint, & only in one direction is called cooter joint

Answer / abhishek

Basically , cotter joint is used in which there is no angular displacement between two rod o the other hand the knuckle joint is used in which there is necessity of angular displacement for e.G." in goods train coneect two goods coach at that time cotter joint does not used.there is necessity of some angular displacement during chanhe a railway track(indian railway)."

Answer / shridnyanesh

knuckle joint is used for high tensile load whereas cotter joint is used for small tensile& compressive force

Answer / oves shaikh

Taper is provided in the cottor joint
And
Taper is not provided in the knuckle joint

Answer / karan

knuckle use knukle pin to hold two shafts bt cotter use a cotter

Answer / yogiraj yelpale

Knuckle joint A knuckle joint is used to connect the two rods
which are under the tensile load, when there is
requirement of small amount of flexibility or
angular moment is necessary. There is always
axial or linear line of action of load.

Answer / jash

knuckle jiont is not there .it is a fack

Answer / sudipto raj

cotter joint are used for compressive force only while
knuckle are primarily used or tensile force

Answer / prayag bhalerao

Cotter consist 6 alphabets nd knuckle consist 7 alphabets
Cotter starts with c where as knuckle starts with k
It consist double t where as knuckle two k

What is wrap-around?

0 Answers  

Which is the best lubricant-air, oil or water?

6 Answers  

How hydrulic power stearin @ lutch works plz explain?

0 Answers  

HOW TO CALCULTE THE TR CAPACITY FOR SCREW COMPRESSOR, RECIPROCATING COMPRESSOR,PHE & COOLING TOWER? HOW TO CALCULATE THE FLOW RATING OF PUMPS?

0 Answers   Sanmar,

why not maintain 7.0 ph in boiler ,when 7.0 is not acidic & not basic so why maintain 9+ ph?

4 Answers  

How to select the shock absorber?...................

1 Answers   BARC,

function and working of ABS?

2 Answers  

Can some one please show me the design of a POT Bearing.

0 Answers   General Motors GM, GM General Motors,

purpose of centrifugal pump casing wear ring and impeller wear ring

10 Answers   Jyoti Ltd, Kirloskar, NPCIL,

Where id the warm side of a refrigeration system?

0 Answers   HCL, RRB,

define jig and fixure?what is diference between jig and fixure?

12 Answers  

Why two stroke engine can’t be used in cars?

4 Answers