Answer Posted / sahil

Knuckle joint is used to connect two rods whose axes either coincide or intersect and lie in one plane, which are subjected to transmit axial TENSILE force on other hand cotter joint is used to connect two co-axial rods, which are subjected to either axial force or axial compressive force.

DOES IS 2062 SPECIFIES ONLY SEAMLESS PIPES OR ERW PIPE IS ALSO COVERED UNDER IS 2062

5621

---

What are you going to inspect or check when you open the crankcase?

1987

---

Why pert is preferred over cpm for evaluation of project ?

1101

---

Specific strength of materials is very high when they are in fibre size but lower when they are in bar form why ?

1672

---

What is the percentage of carbon present in pig iron?

1171

---

Do you work for many hours each day?

1091

---

why we cant measure absolute entropy directly,but the change we can?

2348

---

good book for material science and catia v 5 high scope domin to make career

1350

---

How do you control cylinder liner wear?

1998

---

SOMEONE POST THE MODEL APTITUDE QUESTIONS FOR MRF TYRES PLz pLZ pLZ ..Very urgent

5848

---

what is rolling margin?( from view of machining process ) explain briefly

1879

---

Explain working of a fourneyron turbine?

1116

---

why it is difficult to make heavy cuts if a form turning tool is complex in shape?

2459

---

Draw the flow of F.O. diagram from service tank to Main Engine?

2314

---

What is the difference between isotropic material and homogeneous material ?

1233

---