Hai, iam renjith. my qtn about the calorex heat and cool pump. What is the reason of the above machine is trip on high pressure. r134a gas using in this system. 8 months old. model is calorex propac 90(3 phase). This system has 2 compressor. Both are starting on 13amps after that rise up to around 21 within 1 minute. After will be trip on high pressure. Showing 68 psi in suction side on standby mode. Can i have a solution without delay? Renjith renjithngm@gmail.com

0 Answers  

---

What are all the possibilities discharge will be low in the pumps?

3 Answers   Infotech, UltraTech,

---

in gas pipe line is running, and leakage is take place, if possible with out stop the gas is welding ? how ?

1 Answers  

---

What is the importance of tolerance in engineering?

0 Answers  

---

is pneumatic cylinder can be used as hydraulic cyclider for same pressure.

1 Answers   Bosch Rexroth,

---

Which case we will find maximum pressure and flow in centrifugal pump - circular casing or volute casing ?

0 Answers  

---

My parents green card holder and sister is citizen so... . I m applying for spring 2010 for F1 visa... how can i convince visa officers for visa?

0 Answers  

---

what is hammering of fluid?

2 Answers   Bhel,

---

what are the activities to be done after a steam turbine trips?

0 Answers   ITC Infotech,

---

What is difference between ASME EN & IS related welding procedures(WPS/PQR/WPQ)

0 Answers   Ziemann,

---

What is brain of the computer?

0 Answers  

---

WHAT WILL HAPPEN IF RELIEF VALVE IN HYDRAULIC SYSTEM FAILS?

4 Answers  

---