In control valve there are two type of valve seat we can use metal to metal sea

In control valve there are two type of valve seat we can use
metal to metal seat & soft seat.On this valve seat i have
following doubt.

1)I have never seen practically the internal assembly of
valve so my doubt is that basically weather the seat is soft
seat or metal its basic MOC is same as valve body(SS or CS)
only in soft seat we are using PTFE ring & place on valve
seat & in metal this PTFE ring is not threr am i correct???????
2)what are the common general rule for using metal to metal
seat & soft seat,means its depend on process parameter like
liquid,gas, steam & on valve leakage class.

Question Posted / guest

1 Answers
2615 Views
I also Faced
E-Mail Answers

In control valve there are two type of valve seat we can use metal to metal seat & soft seat.On..

Answer / mrinal

Ball valves operating up to a process maximum temperature of 200 deg. C shall have soft
seats, unless specified otherwise in the project specifications. Beyond this temperature,ball valves or isolation valves shall have metal seated.

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Instrumentation Interview Questions

What are use of positioner.

6 Answers

Is there’s power on the bus (if so, state whether on the signal bus, or on a separate in the following: a) HART b) Profibus DP c) Profibus PA d) DeviceNet e) Foundation Fieldbus

1 Answers EIT,

How to convert mmWc(mili meter water colam) to tph(ton per hour)?

0 Answers

what is hart communicater? can u give brief explanation about this issue?

3 Answers

What is surge and how is it prevented.

1 Answers ADMA OPCO,

What is cv of control valve

4 Answers Cadila,

How does a single acting, spring return ball valve actually work? Does it require continuous air supply?

0 Answers Process Control Technologies,

How to calculate the range of level transmitter?

4 Answers Wika,

Sir i am studying M.sc,(Tech.)Electronics and Instrumentation in Andhra university.What is the offers for me?

4 Answers

why we are using ungrounded RTD sensor and what is difference between grounded RTD and Ungrounded?

1 Answers

generally transmitter power supply having some range(12v to 35v) but the out put(4-20 mA) must same for given input.If we vary the power supply voltage then output mA also to be change according to V=IR. Is there any voltage regulator in the transmitter ?

1 Answers

what is meant by Valve reversibility?

2 Answers

For more Instrumentation Interview Questions Click Here