Interested to Buy Any Domain ? << Click Here >> for more details...
In control valve there are two type of valve seat we can use
metal to metal seat & soft seat.On this valve seat i have
following doubt.
1)I have never seen practically the internal assembly of
valve so my doubt is that basically weather the seat is soft
seat or metal its basic MOC is same as valve body(SS or CS)
only in soft seat we are using PTFE ring & place on valve
seat & in metal this PTFE ring is not threr am i correct???????
2)what are the common general rule for using metal to metal
seat & soft seat,means its depend on process parameter like
liquid,gas, steam & on valve leakage class.
- 1 Answers
- 2616 Views
- I also Faced
- E-Mail Answers
Answer Posted / mrinal
Ball valves operating up to a process maximum temperature of 200 deg. C shall have soft
seats, unless specified otherwise in the project specifications. Beyond this temperature,ball valves or isolation valves shall have metal seated.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How to Calibrate Coriolis Flow transmitter in field
how radio frequency level probes works with its controller ? what is its principle ? pls give me brief explanation?
When doing a liquid seal on a differential flow transmitter , most of the time the sealing liquid will be heavier then the process fluid. For wich application will the sealing liquid be lighter than the process fluid if transmitter is mounted below the process line.
How will you calibrate PID controller? explain with example.
what is function of switch, and how is it work, explain with difination
i have steam drum height 1000mm. and i want to placed the transmitter below the tap.how i calculate.
How to calibrate level transmitter with use of HART?
Explain an adaptive / self-tuning controller’s major draw card.
Displace type LT to be calibrated in workshop, wt. 40, dia- 60 mm, density- 0.8kg/cm3.
1. what is modbus cable? 2. what kind of communication we are using for the interface of DCS, ESD and Third party cabinets? 3. What is serial communication and peer to peer communication?
how will you check torque value during Factory acceptance Test for control valve/ESD ON/OFF VALE how will you confirm this torque value is being correct, Which document will you be refer.
What is Positive Calibration and Negative Calibration?
How to Calibrate Radar Level Transmitter in Field
What is instrumentation instrumentation engineering?
Draw a P& ID showing – orifice flange, plate, dp transmitter, isolation & bypass valves and tubing.
