Answer / raamki

to understand this difference, first u must know what is a
pressure gauge.A pressure gauge is a device that is added in
series to a line where the pressure of a substance is
measured. It is commonly used in hydraulics and pneumatics.
The difference between the analog and digital is that in
analog u must note the pressure values by the movement of
the needle. this may cause the very common error in
measurement called the human error. to avoid this u must
take a set of readings and find an average of them. This
makes too tedious. but in digital u can have an accurate
reading and there is no possibility for human reading errors.

the other reason is that the resolution of the gauge in
digital is more than in analog.

we all know that both the generator and motor are electromechanical conversion devices.....then why we rate motor in kw and generator in kva????

4 Answers   KSEB,

---

for high freq ac,why we first convert AC to DC and then DC to high freq.AC

0 Answers  

---

specific difference of ICT&Auto Transformer

0 Answers   TNEB Tamil Nadu Electricity Board,

---

ple send to the how to improve the efficiency & economical to the thermal power plant

1 Answers  

---

what is the principle of synchronous motors?

3 Answers   The Grand,

---

---

What are the causes of unbalanced current on 34.5kv feeder Ia=0.05,Ib= 0.25, Ic=0.15 and In=0.27 prior to tripping current are balance?

0 Answers  

---

whether choke act as a voltage regulator in tubelight or not?

1 Answers   Bhel,

---

What is Single Phasing fault???(not single-phase fault)

6 Answers   ABB,

---

how we can decide that what value of ht line will come to any commercial building? (ans except According to the building load)

0 Answers  

---

what is the reasons for blowing fuse

1 Answers  

---

what is the difference between potential transformer and capacitive voltage transformer?

1 Answers  

---

in case of OC+EF relay, how the burden is divided/calculated/shared by the CTs in case of normal (healthy condition) and during fault conditions.? three coils of OC & ef coil is conected in residual connection across the three CTS.

1 Answers  

---