Interested to Buy Any Domain ? << Click Here >> for more details...
difference between analog pressure gauge & digital pressure
gauge?
- 1 Answers
- 7684 Views
- I also Faced
- E-Mail Answers
Answer Posted / raamki
to understand this difference, first u must know what is a
pressure gauge.A pressure gauge is a device that is added in
series to a line where the pressure of a substance is
measured. It is commonly used in hydraulics and pneumatics.
The difference between the analog and digital is that in
analog u must note the pressure values by the movement of
the needle. this may cause the very common error in
measurement called the human error. to avoid this u must
take a set of readings and find an average of them. This
makes too tedious. but in digital u can have an accurate
reading and there is no possibility for human reading errors.
the other reason is that the resolution of the gauge in
digital is more than in analog.
| Is This Answer Correct ? | 10 Yes | 1 No |
Post New Answer View All Answers
From past few months I am getting lagging pf even though sufficient capacitors used in circuit. Where is the problem pls answer
What are the material used for resistor?
what is meant by IGBT how they differ from tyristor ?
what is the role and fuction of automatic transfer switch in rotary ups
What is meant by cold loop test in instrument
How to calculate VCB rating for 33KV ,25 MW Power line?
Pl. share your experience about industrial-electronics repair of machine tool.
How to calculate total harmonic distortion level(THD) in VFD? and how can we reduce harmonics?
Instrument connected to a single phase supply
is it necessary to earth the rmu before cutting off the transformer winding?if yes why?
Is there any guideline say about display of earthing value near to earth pit
Dear all, how we select the cable size according to current with or without including different correction factor , is there any direct method for sizing of cable...
Initially, when the input is not equal to the output — what type of response is this?
WE HAVE THE DC RECTIFIER 1500A, INPUT VOLTAGE IS 3 PHASE. HOW TO CALICULATE THE LOAD? 3 PHASE SIDE EITHER dC SIDE. PLEASE SUGGEST ME
What happen when change order of CT in GIS feeder?
