without name plate detail of blower how we can find out the
HP & Rpm ? the input voltage is 230v single phase



without name plate detail of blower how we can find out the HP & Rpm ? the input voltage is 23..

Answer / a.p.nanjappa

voltage is 230v, 1ph. application being exhaust fan,supply
air fan, water pumps, . speed are generally
750,1000,1500,2800rpm.check the fan blades.3,4,6.

Is This Answer Correct ?    0 Yes 2 No

Post New Answer

More Electrical Engineering Interview Questions

We have one 500KVA transformer. We have tested REF relay and commissioned. After one and half year, due to some ground fault in one of the DB circuit Transformer tripped by REF relay. What will be cause and remedy. Please advise?

1 Answers  


whatis the test procedure for lightning arrester which was installed one year back. i want check it whether it is working or not.

1 Answers  


If I want to use capacitor banks at HT (11 KV) side for maintaining power factor then which type of capacitor should I use? Plz give me the specification?? (I am using 1250 Kva transformer (11 KV/433V)).

2 Answers  


how to calculate the mesh earth network resistance in such substation, is there any recommended resistance values with references , thanks!

0 Answers   SRES,


when giving a supply to wounded coil it will get magnetised, but the same is not if it is not wounded on a core..and it is getiing short....why.......

3 Answers  






what is the form factor of DC voltage

5 Answers  


Transmission line design. Say, I have a 1MVA generator and 2 transformers that will have the same load. What would be the proper rating of the trasformers? Is it safe to say, that I will simply divide the total rating of the generator?

1 Answers  


Which has more losses, AC or DC??

4 Answers   Infosys, TATA,


In power transformer YnD0 Vector Group is possible or not? if possible, what will be the vector diagram and what are the conditions?

2 Answers  


IN A MAGNETIC MATERIAL HYSTERYSIS LOSS CAN'T BE REDUCED TO ZERO. HY?

3 Answers  


What happen if a 18 watt fluorescent tube is used on 36watt choke,which one damaged or not damaged, if damaged why that damaged?

2 Answers   Bharat ITI,


why any inductive load need free wheeling diode?

4 Answers   Essar,


Categories
  • Civil Engineering Interview Questions Civil Engineering (5084)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4451)
  • Electrical Engineering Interview Questions Electrical Engineering (16631)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1094)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)