Difference between MCC and PDB

Question Posted / nigamsingh_85

3 Answers
24699 Views
BARC, CDS, NINL, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

Difference between MCC and PDB..

Answer / benedict

MCC Means Motor control center,PDB Means Power Distribution Board.

Is This Answer Correct ?

31 Yes

1 No

Difference between MCC and PDB..

Answer / j.karthik(cce)

MCC:
The MCC means Motor control center. in this MCC
connects the Motors.

PDB:
The PDB means Power distribution board. In this PDB
connects only the feeders(power supply feeders)... i.e the
distribution board means to distribute the powers only...

Is This Answer Correct ?

22 Yes

1 No

Difference between MCC and PDB..

Answer / bhatt

MCC is motor control centre hence it must have back-up fuse
or back-up MCCB/MCB and starter whereas PDB is Pwer DB
which generally feed lighting and normal power load.

Is This Answer Correct ?

14 Yes

2 No

Post New Answer

More Electrical Engineering Interview Questions

in thermal power plant the steam produced is made to cool after falling on the turbine blades. my question is why this is done while the same is needed to heat up again. "jab pani ko wapis garam hi karna hai to thanda kyu karte hai"

11 Answers Bhel,

WHY WE USE 4-20mA

5 Answers Coca Cola,

What will happend if given Vfd out put to step up transformer

0 Answers

Whether the over frequency protection is turbine or alternator and why?

1 Answers Marg,

Is a direct shorth ciruit on a branch MCCB in a Low Voltage Switchboard a correct means of tesing the performance for discrimination?

0 Answers Adani Power,

What are types of central ac plants?

1 Answers HSL,

which %age if losses increases when frequency is increased to 25%

4 Answers Maihar Cement, Siemens,

what are carbondioxide and dcp used in fire extinguishers

0 Answers

what is the formula for efficiency of francis turbine and generator for hydropower? what is best way to select francis turbine and generator?

0 Answers HAL,

What is Harmonics how it is produced and what is the method to control the same

0 Answers Siemens,

WHAT SHOULD BE THE BEST CURRENT RATINGS (PRIMARY / SECONDARY)FOR A CT INSTALLED AT THE INCOMING 11KV PANE? WILL IT BE CALCULATED ON THE BASES OF MAXIMUM DEMANT VALUE OR ON SUM OF ALL TRANSFORMER'S KVA? NOMALLY MAX DEMAND REPRESENT THE MAXIMUM OPERATING LOAD OF THE PLANT AND TOTAL KVA OF (SAY 5 NUMBERS TRANSFORMERS) REPRESENT THE CONNECTED LOAD. WHICH i.e. MAX DEMAND KVA OR CONNECTED KVA ARE BETTER TO USE FOR CT CURRENT CALCULATION? PLEASE ANSWER.

0 Answers

We need to current density & short circuit calculation at 65kA for aluminium & copper busbar.

0 Answers

For more Electrical Engineering Interview Questions Click Here