FOR 16/20 MVA 132/33 KV ONAN/ONAF TYPE TRANSFORMER IT IS
DESIGNED FOR 16 MVA WITH ONAN CONDITION.IT BECOMES 20 MVA
UNDER ONAF CONDITION.LOAD LOSS IS GUARANTEED FOR 65KW AT 20
MVA AND % IMPEDANCE 13.75.
PLEASE TELL US AT WHAT LOAD LOSS AND % IMPEDANCE IT SHOULD
BE DESIGNED FOR 16 MVA AND WHAT WILL BE ITS EFFICIENCY AT
20 MVA?
No Answer is Posted For this Question
Be the First to Post Answer
1.stranded resistance values of motors? 2.how to calculate the resistance values of single phase and 3phase motors?
we have two generators different capacity on 15 MW and other 6MW at 11 KV , 15 MW gen. bus short level current 40KA,and 6MW short level current 25KA,, length of cable 100MTR between 6 MW from 15MW gen. for bus coupling . kindly tell any one can we use both NGR OR one NGR from any GEN. BOTH NGR has diff. rating. Tariq pakistan
Why earthing is necessary for any equipment?
what you mean ct ratio? why use 400/5a,200/5a,150/5a ?
How to Calculate The sag of OPGW in Transmission Line???
Damping resistor provided in open delta (tartiary) winding of a measuring PT at the incoming of a MV inverter drive panel is getting heated up. Can any body explain the reasons and suggest the remedy?
what is diff b/w electrical & electronics ?
what is fundamental difference between voltage and current
why we used stone chips under the transformer area..
why the earth terminal of the three pin plug we are using bigger than the others?
How can we design a HVAC Plant room which includes AHU,FCU,Chillers,Cooling towers, Pumps etc & how will they work? any Drawing if possible?
which capacity of RCCB used for five thousand watt electricity load?