Good Evening all.My question is - For a feed water line to an equipment if i need to measure the flow we will use orifice /magnetic/vortex depend on cost/spec.If i need to measure a ''Alarm''signal and ''Interlock'' from one point i think we can use orifice type in one location with 2 different tapping points - one for alarm and one for an interlock to flow valve..If in case i need to have both these signals(Alarm & interlock) from magnetic flow meter,is it possible??will 2 seperate sensors will be located inbuilt r we can program it ??..i thk we can have one transmitter with these 2 signals...need to know any technical issues are there?pls clarify

3 Answers  

---

In VVVF DRIVES VOLTAGE IS ALSO VARY WITH THE FREQUENCY. HOW? WHAT IS THE DIRECT FORMULA RELATING THESE TWO.

0 Answers   India Cements,

---

What safety precautions you will adopt to work on Steam service control valve?

1 Answers   QAFCO,

---

how eddy current loss in probe and induced gap voltage accros probe trip and shaft

1 Answers   Reliance,

---

what is burner management system?

2 Answers   Alstom,

---

why the positioner output is 3-15psi

5 Answers  

---

Why is a dead weight tester so called by that name?

1 Answers   SGS,

---

What is Modbus communication

0 Answers  

---

What is difference between flame retardant & flame resistance cable? Among which type of cable is used for ESD & Fire and Gas system application?

1 Answers  

---

State bernoulli’s application.

0 Answers  

---

how do we commission inergen system?

0 Answers  

---

Galvanizing.

0 Answers   CCIE,

---