Answer / michael

MLFB - Maschinenlesbare Fabrikazbezeichnung

Why 4-20mA SIGNAL IS PREFERRED OVEA A 0-10v signal?

5 Answers  

---

how to change measuring units from mmwc to cubm/h in rosemount air flow transmitter with hart communicator fluke 744

0 Answers  

---

How does a single acting, spring return ball valve actually work? Does it require continuous air supply? 

0 Answers   Process Control Technologies,

---

Yokogawa dcs normally where will change 4-20 MA to DC voltage( node or I/o cards?)

1 Answers  

---

What is defferent betwen ESP &PCP PUMP .HOW IT IS WORK?

0 Answers   Jindal,

---

Dear all... I have 1 0-400 duplex type RTD, I connected the A side to the temperature indicator and B side to the PLC panel, but when I have observed then found that The PLC side temp has the variation. and it was distub to other RTD temp also. so what can I do.pls help me

1 Answers   Worley Parsons,

---

open tank and close tank leavel transmiter about range and calibration

0 Answers  

---

There is a problem with our HART475 it is not communicating with smart devices error becomes "NO DEVICE FOUND"we have insert 250ohm resistance as per requirement but invain plz tell me the solution?

1 Answers  

---

What is the calibration procedure of Drum level transmitter if range is 0 to -400 mmh2o in lab?

0 Answers  

---

What is mean by analytical instrumentation?

0 Answers  

---

WHICH IS BEST INSTRUMENTATION OR ELECTRICAL ENGG?

3 Answers   SAS,

---

can we copy the software from a transmitter using hht(hart 275) ?

0 Answers  

---