Interested to Buy Any Domain ? << Click Here >> for more details...
Explain what is meant by the term “FLASH POINT” of liquid?
- 2 Answers
- 6340 Views
- I also Faced
- E-Mail Answers
Answer Posted / navneet jain
Flash point is that point it will be start of ignitation of any types of liquid.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
how pressurize drum calibrated ?
Galvanizing.
send me HPCL paper
WHY THE DEGREE OF VALVE PLUG AND VALVE SEAT IS SLIGTLY DIFFERENT I CONTROL VALVE TRIM DESIGN
If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?
why micro controller 8051/52's clock frequency is internally divide by 12 ?? and why it is further divide by 32 in UART serial communication ??
what does the ratio 800-400-300-200/1-1-1-1-1 in the specification of current transformer indicates?
we have level transmitter for h2s04 storage tank capacity 10k ,always there are failure of transmitter due to failure of magnetic floats ,please come up with solutions at the earliest.
need to calculate flow rate with the help of dp range and orifice bore dia and size. range is 0 to 400 inwc and orifice size is 12 inch 150 # rf and bore dia is 7.180 inch. need to calculation for flow rate
What is the PLC configuration in Cement industry?
What is loop1 and loop2 in MTS LT?
-/5A. What is the meaning and limitations of this in energy meter constant. It is a 3 phase LT Energy Meter. If this Energy Meter is connected through a CT of ratio 200/5 Amps, then what is the multiplying constant and how its will be calculated.
If we increase only P what will be controller action ?
what is the calibration procedure for transweigh make weigh feeder?
what is the vital subject for scoring bhel exam&what is the question pattern
