Answer / ajith

the 1ph supply applied to stator wdng cant produce a
rotating magnetic field as in the case of a 3ph induction
motor..
if a 1ph is applied to the induction motor the resulting
magnetic field is only altrnating (not rotating)..
In order to make the 1ph induction motor self starting...,
2 windings are used ..startin windin n runnin wdng..called
split phase motor.. or by connectin a capacitor in series
with the start wdng.. for obtainin necessary phase
diplacement...

Answer / abhimanyu kumar gupta

Single phase IM given single phase supply given to stator
winding an alternating magnetic field develop in stator and
produce alternating flux and collides with rotor winding and
produce induced EMF at rotor since the rotor winding are
closed this produce induced current in rotor.
Due to this induced current in magnetic field of alternating
nature and this nature is not rotating. Both magnetic field
in stator and rotor are Colline's so resultant torque rotor
will 0. Hence single phase IM does not self start.
In order to make motor self start an external force to the
rotor should be given because of locking of field will
disappear.

Answer / venkat

back e.m.f reducing

An input device is interfaced with Intel 8085A microprocessor as memory mapped I/O.The address of the device is 2500H.In order to input data from the device to accumulator,the sequence of instruction will be

1 Answers   GATE,

---

why neutral should connect to earth in delta-star type transformer

4 Answers  

---

Why the capacitor are connected in Delta(Three Phase) for power factor improvement ?

5 Answers   Hero Honda,

---

which type your UPS on line,off line give the reason?

2 Answers   Roto Power,

---

what is the power factor of an inductive load ? (i) Zero (ii) Lagging (iii) Leading (iv) Unity

5 Answers  

---

how capacitor pass ac voltage practically?with increase frequency and cpacitance?

1 Answers   DELL,

---

what is mean by drives?

0 Answers  

---

why we use to always generate power below 16kv.why not at higher voltage?

3 Answers  

---

I have a relay contact rated at 220v dc which is supplied with a 24vdc from the panel,for it to trip the dampers(24vdc).What if the application of the relay changes so that it should work at its rated 220vdc then will it work at 24vdc supply given or any other consideration needs to be taken .....

0 Answers  

---

what is meaning of AMF, WHY IS USING IN GENSET

1 Answers  

---

A 11KV, 1200 A breaker combination fixed in a cubicle for HT motor.Is normally for 11 KV motor fuse is using? if Yes, What range fuse is required?

0 Answers  

---

what is the formula to find Amp. for an 3 phase moter both if H.P. or if kW is known?

5 Answers   Uttam,

---