what is the different between rms and average value
Answer / abbas krishnagiri
RMS= root mean square value = Im/root2
average value= 2Im/py
| Is This Answer Correct ? | 7 Yes | 2 No |
what happens when current(ac or dc)flowing through a boucket of water?please describe it.
During the main stator winding insulation testing (phase to ground)of 11kv alternator (Lerysomer) i found 0 and resistance with multimeter and found 20 killo ohm while the power cables are connected both end (Generator & VCB). In VCB PT (Potential transformer) are connected. Please any body explain that method of insulation is correct or not? also describe of PT connections
what are the interview question asked in wind mill about electrical
if a 3 point starter is not available, how can a dc motor be started?
3 Answers Accenture, BIT, Techno Solutions,
My meter ratio is -/5 and ct ratio is 100/5 now what will be the multiplying factor and how ?
What Should be the value of Vector Surge angle at Tripping and how to calculate it?
how to connect the three phase capacitor in three phase star/delta connection motor?
Different between megger and contact resistance meter
what is motor?
the single phase voltage is 230 volts and threee phase is 430 v.why three phase is not 660 v?
for same rating of a transformer and induction motor which one will have higher magnetising current flowing?
Two 11 kv lines are feeding to common bus in a substation,I have one set of CT & PT(3ct,2pt), How can I measure both lines power using single set.
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)