Answer / a.k badhan

as u know module is .
pitch circle dia. divide by no. of teeth
in more simple
if no. of teeth more dia is small so teeth module is so small.
if no. of teeth less dia large so teeth module is large .
last thing after looking gear u easily understand.

Answer / ravi kumar singh

Gear module is the ratio of diametrial pitch to the no. of teeth.

Dof of Water is.... critical temperature

0 Answers   NTPC,

---

where can i get railway junior engineer(mechanical) previous years question papers?

0 Answers   Bhel, RRB,

---

how vaccum create in watering vaccum oump?

1 Answers  

---

Why did you choose this career as an engineer

6 Answers   HCL,

---

2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand

0 Answers  

---

Do you have idea about various methods of production of gears ?

0 Answers   John Deere,

---

How will we know in which direction a liquid is flowing in a pipe?

34 Answers   BARC, DRDO,

---

Types of pressure

2 Answers   ABC Inc, RRB, Siemens,

---

What is long form of FIAT

4 Answers  

---

What is the materials of jib?

0 Answers  

---

what is the ejection system in mould making?

2 Answers  

---

WHY TORSION SHAFT IS GIVEN IN BALL MILL DRIVE. IS THIS HAS A ANY TECHNICAL REASON?

1 Answers   Satyam, Wipro,

---