Answer / jeyaganesh.g

The Ejection System is used to remove the part from the
core and cavity,
the ejection system includes, ejector pin ,
this system always mounted from core side.
Ejector system also can designed in design
level.

Answer / rajashekar

ejection sysemis for the ejection of mould , by using of
ejection pins ,which can be operated by compreesor

What is surging in centrifugal compressor. how its happened and how to avoid it.?

10 Answers  

---

how can we improve the efficiency of marine ship?

1 Answers  

---

hardness of grinding wheel is specified by

8 Answers   NTPC, TATA,

---

What will be the cause of high temperature in one cylinder of D/E?

0 Answers   RRB,

---

why we use kg/cm2 instead of kg/m2 as a unit of pressure. As we know kg is a MKS unit and cm is a CGS unit. So why we use combination of both(kg/cm2)while describing the pressure.

3 Answers   IES, NTPC,

---

Do you receive good benefits as an engineer job?

0 Answers  

---

Would you be able to join our organization in a month"s time?

0 Answers  

---

Which two elements have same percentage in proximate and ultimate analysis of coal?

0 Answers  

---

how to calculate stiffners position and size in transformer design

0 Answers  

---

How do you measure the moment of inertia?

0 Answers  

---

Corundum mainly Contains__________

1 Answers   Behr, Bhel,

---

IN THERMAL POWER PLANT WHY WE ARE USING SINGLE SHAFT FOR THE COUPLING OF HP,IP&LOW PRESSURE TURBINES....WE CAN USE INDIVIDUAL SHAFT FOR EACH TURBINE....?

2 Answers  

---