Answer / sahil prajapati

If the Amount of Apply the force is called as Pressure

how to convert digital signal to analog signal in plc

1 Answers   UltraTech,

---

You are looking at the RS-485-side of an RS-232/RS-485 converter and the power supply voltage for the converter is +5V. Under idle conditions (no transmission), and assuming you have enabled the RS-485 output: what would you expect at: (a) Output A measured against output B (b) Output A measured against ground (c) Output B measured against ground

1 Answers   EIT,

---

what is the deference bitween DCS and PLC SCADA HMI System for Power Process Industry.

1 Answers   UltraTech,

---

How process line mpm calculation is done?

0 Answers  

---

what is plc?

27 Answers   HPCL, KRL, Noor Company, Petrochemicals, SS Automation,

---

while am calibrating Drager polytron 2IR flame gas detector occured non zero status.how can i get zero status?

0 Answers   Gasco,

---

any one suggest me how to calculate percentage of air leakage with formula,

0 Answers   SSL,

---

What is Trim?

1 Answers   Gujarat Borosil,

---

I want to measure level under vaccum by using DP Tx and vaccum vary between -500 to -670 mmHg and process fluid is accetic anhydride if consider process fluid density 1 kg/cm2. how to calibrate Tx ? consider level is 0 to 100 Cm.

1 Answers   CCC,

---

What is the relationship between GAIN and PROPORTIONAL BAND.

1 Answers   Kharafi National, Sabic,

---

hi am durga, i just now completed my eie [2009] , can anyone please guide me what r courses i need to join to enter into core company

6 Answers  

---

whats the working principle of level transmeter?

6 Answers  

---