in dc machines in the armature nature of power is ac but
why we take rasistance instead of impedance?
Answer / karthik_elec
the induced power is ac but the commutator segment convert
ac in to dc, so we dont want to take impedence, if u go
deep there is negligible impedence,
Is This Answer Correct ? | 3 Yes | 2 No |
standard earthing rating for power line..
In UPS, battery connections if parallel connection given, what will happen?
I have 4 busbar of 1000 ampere. we use 4 busbar to make 4000 ampere in one phase.my problem is that when we applied 60% load on that then busbar produced high noise.what is the reason of that and how can i minimize that noise.
0 Answers College School Exams Tests,
what is doubling factor in making current of a breaker?
brief notes on ammeters
There is 15 KVA UPS using for single phase load.And 30 batteries of 12 V, 100 Ah are connected in series. Load is taking 15 A current.What will be the back up power for this UPS on same load?
1 Answers BS, Dynamic Software,
i have 2kv ups how many watts batteries is required
What willbe change in programming when we use 5/3 solenoid inplace of 5/2 in operating of a cylinder?
how the reverse power relay acts..
There is two transformers of 2MVA & 3MVA, which transformer is located at the sending end & which is at receiving end. why?
I would like to know that the fault curretn at base load and at 10% generation will be same? Fault level of BUS remain same with different generation?
what is use of governer in diesle engine