Why different types of connection in transformers are used?
(star/star,star/delta,delta/star,delta/delta)Why we are
only taking in consideration of star/delta type
transformers? if only star/delta is good in practice where
doses other type of transformers are used? Note: i want to
know place of using different types of transformers other
than Star/delta type with brief description.
- 1 Answers
- 7112 Views
- Electrical Tech, I also Faced
- E-Mail Answers
Answer / anil
star delta is used at the transmission side
star star is used for low voltage supplies
delta delta is used for higher voltages
delta star is used at the recieving end of the transmission
| Is This Answer Correct ? | 13 Yes | 11 No |
The coulomb is a unit of:(a) Energy(b) Voltage(c) Power(d) Quantity of electricity
How to convert 2 phase to 3 phase electricpower in induction moter?
Define bibo stability.
a 50hz motor to give 60hz whats happening in motor.what happen the motor.
Pls tell me whether we can use EN3A material for shafts of Permanent magnet alternator.What will be the effect of magnetic and nonmagnetic material for shafts on magnetic properties of PM rotor .
can i know how to design overcurrent setting and earth fault for 11kv & o.433kv system assuming tx 1000kva.
* Signal transmission in sky wave propagation is due to ? a) Reforction of wave b) Reflection of wave c) Pierus through Inosphere d) None and Reason for this is????
What are the specifications for getting approval of Substation?
How to run 1ph motor(230 VOLTS its full load amps is 4.5 ampa))with 480 volts main(we didn hav neutral)Thn we go for step down transformer.Our load 10 amps,so we conisder this amps in primary are secondary side
We normally make oil soak pits under Transformers. Oil from soak pit goes to collection pit. We provide granules/pebbles under transformers. My question is weather granules/ pebbles to be filled in soak pit or not? if yes upto what level?
Define delay time.
In VVVF drive voltage is varying in accordance with frequency.My question here is How much will be the voltage in the inverter side if the frquency is set for 10Hz ?
-
Civil Engineering (5085) - Mechanical Engineering (4451)
- Electrical Engineering (16632)
- Electronics Communications (3918)
- Chemical Engineering (1095)
- Aeronautical Engineering (239)
- Bio Engineering (96)
- Metallurgy (361)
- Industrial Engineering (259)
- Instrumentation (3014)
- Automobile Engineering (332)
- Mechatronics Engineering (97)
- Marine Engineering (124)
- Power Plant Engineering (172)
- Textile Engineering (575)
- Production Engineering (25)
- Satellite Systems Engineering (106)
- Engineering AllOther (1379)
