1) what do you mean by rolling margin of steel ? 2)pls. tell the cut length for

1) what do you mean by rolling margin of steel ?
2)pls. tell the cut length formula of stirrups as per IS
codes(take out cut length for a beam of 600*300mm with 40mm
cover all sides)?
3)what is the multiplying factor of painting for sand faced
plaster?
4)if your footing is of size1.9*1.6m . what quantity of
length and width you will excavate means what extra
margins you will allow as per IS codes in billing?

Question Posted / rohit_rangnekar1975

1 Answers
5868 Views
I also Faced
E-Mail Answers

1) what do you mean by rolling margin of steel ? 2)pls. tell the cut length formula of stirrups as ..

Answer / sahilshah.civil@gmail.com

a) Rolling margin is percentage difference between actual weight vs standard weight of steel have same length. - generally vary 2-3%

b)Cut length of stirrups L = 2 X (600-80+300-80) + 15 X 8 = 1600 mm

Is This Answer Correct ?

2 Yes

0 No

Post New Answer

More Civil Engineering Interview Questions

how much overlap i must to provide in column 16mm dia bar and if i want to save steel by doing welding then how much over lap must be?

3 Answers Bin Hamda Trading Contracting,

In foundation design, while we do the base pressure check, we normally check if the attained pressure value is less than the GROSS BEARING CAPACITY of the soil which is the sum of net bearing capacity of soil and the overburden pressure. Actually, the overburden pressure acts against the net bearing capacity of the soil and I feel that we are actually increasing the bearing capacity value and doing the check. I feel that this is NOT right. Please clarify on this.

0 Answers

As column is compression member then why we use steel to make it reinforced as it is already capable of taking compressive load?

2 Answers MBL Infrastructures,

I want to know the material required per Square foot in rcc roof i.e.Steel ,Cement,

0 Answers Das Infratech,

internal dia of sewer pipe should not be less than A] 15 cm B ] 20 cm C ] 25 cm

2 Answers

what is the quantity of cement( in bags),sand and aggregates required for 1 cmt of M 25 concrete

3 Answers

What is the ratio of grades m5, m7.5, m10, m15, m20, m25, m30, m35, m40?

0 Answers

strength vs shape factor

0 Answers

whike making bbs we deduct 2d for every bend in bar but theoretically we cant subtract 2d for every bend and for every dia of bar , so plz tell me the exact deduction for bends for different dia of bars and for different angles ??

1 Answers Sobha Developers,

How to calculate the amount of cement & sand required for plastering work with ratio 1:4 please give me an answer with detailed step.

6 Answers DSR Management, Simplex,

how much sand requires for Light weight blocks for 100sqft

1 Answers Bahria Town, NCC,

what is concrete

9 Answers

For more Civil Engineering Interview Questions Click Here