Answer / karuppasamy

TWO STEEL BARS CONNECTED AS PER LAP LENGTH. LAP LENGTH IS
45D TO 50D. (50 TIMES OF THE DIAMETER OF THE BAR.)

Answer / munivel

Lap length is the overlap length of reinforcement
for the purpose continuity and to transfer the loads also

Answer / vijayaraj24

Two steel bars connected as per lap length.lap length is 45d to 40d to 45d (45 x diameter of the bar)

Answer / v.kapil

the length require to transfer full load / force from one
bar to another. it depends on dia of bar, nature of load (
tension / compression) and grade of concrete.
as grade of concrete increases lap length should be
decreases.

Answer / kamlesh

It is the length of same dia. of Steel bar which is overlap with each other. The lap length is used to continue the steel bar as per the requirements. The lap length is in between 50D to 60D. (D is the dia. of bar)

Answer / kumars

As a Thumb Rule u Can take it as 50d.it defer from 45-50d.

how to calculate total cost for slab 35'×8'

0 Answers  

What is the best design for building bridges?

6 Answers  

6mm dia rod legth 1feet

5 Answers  

how can can column be corrected when the design is not safe ? is the increasing the clearcover a solution?

0 Answers  

In a concrete grade C35A, C & A stands for what and equalent cube strength?

0 Answers   SK,

Can we use 16mm dia bar in place of 12mm dia bar in COLUMNS? (if given dia bar is not available on site)

5 Answers   Clover, Rites,

what is escalation?how it is done?

0 Answers   Vishal Nirmiti,

how many area req.in 15000liter water tank

7 Answers  

6. What would your co-workers say about you?

0 Answers  

WHAT IS FLOOR AREA RATIO? Y IS IT NECESSARY? HOW TO CALCULATE IT?

1 Answers  

What are the applications of modulus of elasticity?

0 Answers  

What is design life of a bridge?

3 Answers