what is bus PT ?

Answers were Sorted based on User's Feedback



what is bus PT ?..

Answer / krajeshkumar1989

bus pt means bus potential trnsformer
it is used to measure the voltage in the bus and it is very important at the time of synchronising.

Is This Answer Correct ?    1 Yes 0 No

what is bus PT ?..

Answer / achita rao

IN SUBSTATION BUS PT ARE USED FOR MEASURIN HIGH VOLTAGE IN THE BUS

Is This Answer Correct ?    0 Yes 0 No

what is bus PT ?..

Answer / chetan

PT is a potential transformer which is use to meassuremet
or metering of voltages.

Is This Answer Correct ?    1 Yes 2 No

what is bus PT ?..

Answer / deadzg_devil

Because in power stations large current flows thru the
cables n for measurement of currents or any fault the
apparatus required must be highly rated n it wud be costly.
Therefore PT's are used to step down the current to lower
levels for measuring them

Is This Answer Correct ?    1 Yes 3 No

Post New Answer

More Electrical Engineering Interview Questions

what will happen if capacitor bank is used in generation side?

2 Answers  


1600 KVA ka transformer hi aghar lt side par 800A aur voltage 420 ho to HT side ki cable ki rating keya ho gi?

0 Answers  


is it possible to give the total load from the supply generator's maximum in practical?

2 Answers  


what are the effects on an power plant and consumers if the power factor is increased or decreased?

2 Answers  


what will be the effect if we increase the excitation of a alternator??

3 Answers  






why in power staions distriution r like 11kv,33kv,66kv in india?

4 Answers  


How to calculate voltage drop loss in HT 11000 Volts XLPE Aluminium conductor cable. Any specific formula or Thumb rule

2 Answers  


Fot testing new star-delta 132 kw motor in electrical worshop.we should check in star or delta connection as we do not have higher capacity cable in worshop?

4 Answers   Adani,


If DG runing time Neutral earth connection Dissconect what will be the effect in load and equipments.

3 Answers   GE, HP, Reliance,


if 50hz transformer is required to be run on 50% frequency what needs to be done???????????

6 Answers   century,


why generator one end side star neutral point given? if this point not given what happen?

1 Answers  


how to build a network which step down 415v to 1v rms

0 Answers  


Categories
  • Civil Engineering Interview Questions Civil Engineering (5084)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4451)
  • Electrical Engineering Interview Questions Electrical Engineering (16631)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1094)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)