why wave traps are placed only at y and r phase?




Answers were Sorted based on User's Feedback



Answer / eby

Most secure communications through these phases

Is This Answer Correct ?    0 Yes 0 No

Answer / tapasi

wave trap is a instrument used in substations to eleminate
the communication & unwanted waves tranported with the
current. it is generally connected with y & r phase because
the substations r communicate with each other through these
lines.

Is This Answer Correct ?    4 Yes 9 No

Answer / chinga

becuuse subststions are communicate with each other with y
& r phases only.

Is This Answer Correct ?    1 Yes 10 No



Post New Answer





More Electrical Engineering Interview Questions

what is demagnetising effect & crossmagnetising effect and how it is related to electrical system?is there any more effects are available or only these two??

1 Answers   Telco,


As we use capacitor bank in 3ph ckt to improve PF, can we use capacitor in single ph domestric use, in house we have Fan,Mixer,electric cooker,iron,tube choke they also lag the system,because it is inductive load. if it is possible to improve PF of single ph system-- if yes- type of capacitor to be used,connection diagram, working in detail. if no-- list it.

0 Answers  


How to check VFD outgoing voltage

1 Answers  


Why we need to carry out knee point voltage test of current transformer ?

1 Answers   Power Grid,


Pl. share your experience about industrial-electronics repair of machine tool.

0 Answers  






what is the purpose of using filters in a protective relaying scheme?

0 Answers  


what is the full form of FRL (3/20,7/20 EARTH WIRE)..????

3 Answers   Divis Laboratories, Aster, FRL, Gasco,


why the CT ratio secondary is always divided by 5 for eg( 75/5,80/5,50/5)

6 Answers  


why usa use 60hz and 110v?

2 Answers  


whats was the problem if neutral and earth got 2volt from the ups output

1 Answers  


Why oil preferred over the air as a cooling medium for high rated transformer?

1 Answers  


what is power factor? whether it should be high or low? why?

11 Answers  






Categories
  • Civil Engineering Interview Questions Civil Engineering (4597)
  • Mechanical Engineering Interview Questions Mechanical Engineering (3682)
  • Electrical Engineering Interview Questions Electrical Engineering (15682)
  • Electronics Communications Interview Questions Electronics Communications (2631)
  • Chemical Engineering Interview Questions Chemical Engineering (742)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (78)
  • Bio Engineering Interview Questions Bio Engineering (30)
  • Metallurgy Interview Questions Metallurgy (95)
  • Industrial Engineering Interview Questions Industrial Engineering (198)
  • Instrumentation Interview Questions Instrumentation (2859)
  • Automobile Engineering Interview Questions Automobile Engineering (171)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (41)
  • Marine Engineering Interview Questions Marine Engineering (60)
  • Power Plant Engineering Interview Questions Power Plant Engineering (166)
  • Engineering AllOther Interview Questions Engineering AllOther (1328)