Answer / vasudevan

An isolation transformer is used to isolate the primary and
secondary circuits.To protect the source equipment from any
voltage or earth fault in the load circuit.this transformer
mostly used in induction loads

Answer / mahesh unni

An isolation transformer is a transformer used to transfer
electrical power from a source of alternating current (AC)
power to some equipment or device while isolating the
powered device from the power source, usually for safety.
Isolation transformers provide galvanic isolation and are
used to protect against electric shock, to suppress
electrical noise in sensitive devices, or to transfer power
between two circuits which must not be connected. Isolation
transformers block transmission of DC signals from one
circuit to the other, but allow AC signals to pass.

For more information check:
http://en.wikipedia.org/wiki/Isolation_transformer

Answer / guest

An isolation transformer is a transformer used to transfer
electrical power from a source of alternating current (AC)
power to some equipment or device

What is the definition of direct acting valve & reverse acting valve

2 Answers  

---

What is i/e or o/p transmitter(ma/v)?

1 Answers   Emco,

---

How can we calibrate the level interface for Fisher® FIELDVUE® DLC3000?if use water to calibrate and our liquid SG are 0.75 and 1 ,Displacer height=14" and How much should be set SG in trasmitter during calibrate,for URV and LRV how shold be set

1 Answers  

---

relation between level and differential pressure.

3 Answers  

---

State some of balance principle’ advantages?

1 Answers  

---

Wht should be the ratio of natural frequency (Fn) to wake frequency (Fw) and wht if goes above the rato limit?

2 Answers  

---

Good Evening all.My question is - For a feed water line to an equipment if i need to measure the flow we will use orifice /magnetic/vortex depend on cost/spec.If i need to measure a ''Alarm''signal and ''Interlock'' from one point i think we can use orifice type in one location with 2 different tapping points - one for alarm and one for an interlock to flow valve..If in case i need to have both these signals(Alarm & interlock) from magnetic flow meter,is it possible??will 2 seperate sensors will be located inbuilt r we can program it ??..i thk we can have one transmitter with these 2 signals...need to know any technical issues are there?pls clarify

3 Answers  

---

thru which signal does µP communicate with memory

3 Answers  

---

what is KV and XV valve

1 Answers  

---

hi i'm an Instrumentation student,i have one doubt that we can call- > computer science as CS > Information science as IS > Electronics & communication as E & C In the same way what is short term for Instrumentation....?

11 Answers  

---

what is mapping in instrumentation and control engineering

2 Answers  

---

in differential pressure transmitter,min&max pressure range for hp&lp

1 Answers  

---