Answer / umesh parmar

Pipe is used for conveying fliud without any heat transfer
whereas tube is used for conveying fluid with heat hransfer.
Therefore Pipe is thick according to d/t >10 and tube is
comparatively thin, as Mr. Bommuraj said.

Answer / vikas

The primary difference between pipe and tubing is how the
size is designated. Pipe is designated by a "Nominal Pipe
Size" based upon the ID (inside diameter) of the most
common wall thickness. Tubing is designated by the measured
OD (outside diameter)

Answer / bommuraj

pipe must be thick according to this formula d/t>10,tube shoul
be thin

Answer / magesh

Pipe is designated by a "Nominal Pipe
Size" based upon the ID (inside diameter) of the most
common wall thickness. Tubing is designated by the measured
OD (outside diameter)

Answer / nori vsn murthy

The fundamental difference between pipe and tube is:

Pipe is for mass transfer applications, whereas, tube is
for heat transfer applications.
Due to this fundamental difference, we generally call pipes
and tubes as: water pipes, steam pipes, slurry pipes,
boiler tubes, heat exchanger tubes, radiator tubes, etc.

Answer / teekaraman

A pipe is having a circular cross section but tube is not
like that it may have any cross sections like
cirular,square, oval

Answer / ajay kumar

In the pipe may with thread 9 internal/external But in tube
thread never require.

Answer / hardik

mr vikas said that is right

Answer / chkr

vikas ans. in correct.

Answer / mr. mechanical engineer

Pipe is in cylindical shape & tube shape is not fixed
Pipe both end are open & tube has one end closed"
Pipe transfer mass flow
& tube conveyed heat transfer.

wap to insert an element in array at a particular location

0 Answers   CLG,

What is usage of rotameter and hydrometer.

0 Answers   John Deere,

what is thermocouple

8 Answers   MAHINDRA,

Why required STORE to Factory?

2 Answers  

sir, i am completed in diplamo. can i join in iit, anna univercity as lateral entry. pls reply me sir.

0 Answers  

from where u will get friction factor 'f' in darcy's formula?

7 Answers   IGCAR,

4 stroke engine have how many suctions

1 Answers   Varun Motors,

What is TTT involve in power plant

2 Answers   Nalco, OPG,

define eccentricity and principle

1 Answers   DEWA,

We have 6-axis wotan horizontal milling & boring machine. Linear axis- x,y,z,w & U. Rotary table B Axis Z,U & W axis are parallel. Z is tool axis. X is cross slide. We wish to retrofit the machine.Which control I should select & also suggest How many axis simutaneous control for linear & circular interpolation.

0 Answers  

how water get evaporated in cooling tower

4 Answers  

What is the difference between bolt and screw

3 Answers